Daugiau prekių.
Prekių nerasta

USB CH340T perėjimas

New CH340T USB to Serial Port Adapter Board + 2.4G NRF24L01+ Wireless Module F

Skaityti daugiauShow less
Kaina 6,00 € (su PVM)
Išparduota
Prekės kodas:
AN0087-1
Aprašymas
This moduel is an USB adpater /
programmer for ESP8266 moduels of type ESP-01.
It is conveniently fitted with a 2x4P
2.54mm female header to plug the ESP01
(according to illustration picture 2)
and configure or run it right away.
A large 1000μF cap will help getting a steady 5.0V VCC
from the USb bus and and jumper (on the right of the 2x4P header)
will help configuring the GPIO0 line according needs.
The module is based on the USB-UART bridget CH340
from WCH which is compatible with all platforms.
 
Note : for an usage with Arduino ESP8266 platform and for Arduino IDE
it is necessary to switch manually the GPIO0 state for working mode,
in order to get a fully automatic upload it is most likely possible,
for a very limited effort, to assign an unused control line
from CH340 to driver the GPIO0 line
(probably at the cost of a necessary logic inversion),
refer to the CH340 datasheet and
most important to the NodeMCU V0.9
which use the CH340 and already implements this solution,
the schematic is open source and easily available.
Skaityti daugiauShow less
Produkto Aprašymas
AN0087-1
Atsiliepimai
Nėra komentarų
6 kitos prekės toje pačioje kategorijoje:
Nuoroda: AN0214-25 / 0149 / PPK283
Kaina 8,90 € (su PVM)
USB ISP (USBASP) programatorius Atmel firmos mikrovaldikliams. Programatoriaus jungtis standartinė 10 kontaktų ISP. Programatorius aliuminiame korpuse. Norint programuoti Arduino plokštes reikalingas 10 kontaktų ISP...
Nuoroda: AN0087 / 7571
Kaina 6,00 € (su PVM)
Šis adapteris skirtas ESP8266 WiFi siųstuvų programavimui kompiuteriu. Tirint šį adapterį pakaks ESP8266 tiesiog įsistatys į jį ir galėsite įstatę į kompiuterio USB lizdą perprogramuoti ESP8266. USB-UART keitikliui...

Meniu

MENIU